Synthetic Vs. Non-Synthetic

Planning on grabbing some Mobil 1 Extended Performance Motor oil 5W-30 from Canadian Tire. Mazda Protege 2.0L engines intake 3.5L of motor oil during normal consumption. While doing an oil change it’s customary to replace the oil filer and change the magnetic plug bolt before reinstalling. Regular maintenance vary from make and model but for […]

Mazdaspeed Protege Exterior

I purchased a Mazdaspeed protege front bumper including the lip and noticed a major transformation after painting/ installing the MSP exterior face lift. Since only 2000 MSP were produced in North America, I was very lucky to find the Mazdaspeed front end with the lip in Ontario. More useful information about the Mazda Protege family can […]

AEM Short Ram Intake

I purchased a used AEM short-ram intake with a Dry flow filer. The installation process was fairly simple which required removing the stock intake piping/filter/ Mass Air flow sensor and replacing with the new parts. Its always advised to clean thoroughly when installing used engine components to your vehicle. Above all, always disconnect the negative […]

Painting Wheels

I just plastidip’d my rims today but the sun set before I could get started on the other two. Took the other rims off and slapped on my winters as temps.. Here’s the progress so far: Final product.

Body Kit/ Wheels Installed

Finally got all the parts painted and installed. I’m really happy with the exterior improvement of the ride . After installing the side skirts, I noticed a small gap between my rocker panel and skirt. I was worried about washing the car and having water seeping and rusting my rockers. So I decided to fill the […]

Fog light Install

The fog lights installation required collection 3 major components to make the lights work properly. The fog light relay Fog light switch The sedan fog light wiring harness To start the installation I had to disconnect the battery and remove the front bumper. After doing so I aligned the fog light brackets with the bumper […]

Altezza Tail Lights

    Picked up a set of Altezza tail lights for the protege. The installation was fairly simple, all it required was unscrewing the 3 mounting nuts in the back of the tail lights and the light wiring harness just clips right in.