I purchased a used AEM short-ram intake with a Dry flow filer. The installation process was fairly simple which required removing the stock intake piping/filter/ Mass Air flow sensor and replacing with the new parts. Its always advised to clean thoroughly when installing used engine components to your vehicle. Above all, always disconnect the negative […]
I just plastidip’d my rims today but the sun set before I could get started on the other two. Took the other rims off and slapped on my winters as temps.. Here’s the progress so far: Final product.
Finally got all the parts painted and installed. I’m really happy with the exterior improvement of the ride . After installing the side skirts, I noticed a small gap between my rocker panel and skirt. I was worried about washing the car and having water seeping and rusting my rockers. So I decided to fill the […]
Picked up a set of Altezza tail lights for the protege. The installation was fairly simple, all it required was unscrewing the 3 mounting nuts in the back of the tail lights and the light wiring harness just clips right in.
To Do List 2012: – Front, rear and sides lip purchase – Paint all lips and install – Black 16-17″ rims – Customize grille with mesh – Fog light install Finding the correct parts and pieces took a bit of research for example how the Mazda Speed body kit was distributed between different models such […]